How To Use The Electric Home Care Bed

1. Body position adjustment: Hold the head position control handle tightly to release the self-locking of the gas spring, the piston rod extends, and at the same time drives the head position bed surface to slowly rise. Lock in this position; also hold the handle tightly and apply downward force to lower it; the lifting of the thigh bed is controlled by the thigh rocker; the lifting of the foot bed is controlled by the foot control handle. The pin is separated from the positioning hole and descends by its own weight. When it reaches the required angle, loosen the handle of the electric nursing bed, and the foot bed surface 12 will be locked in this position; the coordinated use of the control handle and the crank handle can make the patient get from supine to supine. Semi-recumbent, bent legs, sitting flat, sitting in various postures. In addition, if the patient wants to lie on the side in the supine state, first pull out one side of the bed, turn down the side rail, and press the control button on the outside of the electric nursing bed with one hand to release the side gas spring. Self-locking, its piston rod extends, and drives the side bed surface to rise slowly at the same time. When it rises to the required angle, release the control button and the bed surface will be locked in this position, and the side lying position will be completed from the surface. Note: reverse use Same operation.

2. Use of the defecation device: turn the defecation rocker clockwise, the toilet hole cover is automatically opened, and the toilet carrier is automatically sent to the patient's buttocks in the horizontal direction. The patient can defecate or clean the lower part. Then the bed hole cover is closed and kept flush with the bed surface, and the bedpan is automatically sent to the operator's side, so that the nursing staff can take it away for cleaning, and the cleaned bedpan is put back into the bedpan carrier for next use.

3. Use of the guardrail of the electric nursing bed horizontally hold the top edge of the side guardrail, lift it vertically upwards by about 20 mm, and turn it down 180 degrees, then the guardrail can be put down. Press vertically to complete the side rail raising. Note: The foot rails are used in the same way.